Proper Operation
Learn how your appliance is supposed to operate so you can determine if it is malfunctioning.
This page contains affiliate links. For more information visit our
FTC disclosure page.
- Visit our sponsor for parts:
Maytag Washer Belts
There are two belts under a Maytag 'Dependable Care' washer; one for the main drive pulley and one for the water pump. The main drive belt is designed to slip on the motor pulley until the basket comes up to speed so it gets some wear and tear. The water pump belt does not slip and usually wears less.
Replacement Part Numbers
The main drive belt part number is 211125 and the water pump belt part number is 211124. Both can be purchased in a single package under number 12112425 which is usually slightly cheaper than buying them individually and also contains installation instructions.
To replace the belts, unplug the washer and pull it out away from the wall about a foot. Tilt the washer back and prop it up with something sturdy because you are going to working under it.
Reach under the washer and guide the old belts off the motor pulleys. The motor has tension springs that will provide slack in the belts to get them on and off. Make sure the motor carriage is free to move back and forth. It not, there may be a problem with the carriage rollers or springs.
Put the new belts on in the same order that you took the old ones off. The main drive belt is the biggest one. Make sure the pump belt has play as illustrated above. When the center is squeezed together, the pump belt sides should be no further apart than 1/4" or it is too tight. Once installed appropriately, lower the washer and push it back against the wall.
Click the banner to visit our sponsor to purchase parts:
